RevPi Connect has 6 LEDs for status display. You can freely assign the LEDs A1 and A2 for your project. The status bytes you need for this can be found here.
Further LEDs are already occupied. Their signals have the following meaning:
LED’ s on the left side
LED | Signal | Meaning |
---|---|---|
PWR (Power) | on, green | Your RevPi Connect works. |
on, red | An error has occurred. Check that all cables are plugged in correctly. | |
A1/A2 | – | You can freely assign the LEDs A1 and A2 for your project. The status bytes you need for this can be found here. |
LED’ s on the right side
LED | Signal | Meaning |
---|---|---|
WD (Watchdog) | on, green | All system components are working. |
blinkt einmalig, rot | Watchdog has detected an error and restarted the system. | |
REL | off | Open Contact |
on, green | Closed contact. | |
A3 | – | You can freely assign the LED A3 for your project. The status bytes you need for this can be found here. |