Instructions for Installing Jessie from a Linux Host
Posted: 14 Mar 2018, 20:36
I hope this isn't a duplicate of an instruction, which I didn't find:
Code: Select all
Update to Jessi from a Linux Machine
====================================
Tested on a Linux Mint 18.1
---------------------------
Get and compile rpiboot from the Raspberry Pi Foundation:
> git clone --depth=1 https://github.com/raspberrypi/usbboot
Cloning into 'usbboot'...
> cd usbboot
> sudo apt install libusb-1.0-0-dev
> make
> sudo ./rpiboot
This waits for the Compute Module
Connect your RevPi with the USB cable to the micro USB connector and power it up.
This mounts now a new device under /dev/sdX
Create a backup of your RevPi (assuming RevPi is on /dev/sdc, check this with lsblk)
> sudo dd bs=4M if=/dev/sdc | pv | sudo dd of=backup.img
download the jessie image from the kunbus shop
https://revolution.kunbus.de/shop/de/jessie
extract the zip file
Check the MD5 sum:
> md5sum 2017-09-22-revpi-jessie.img
Write the new Jessie image to the RevPi:
> sudo dd bs=4M if=2017-09-22-revpi-jessie.img | pv | sudo dd of=/dev/sdc
wait for 31:18 minutes (2.1 MB/s)
disconnect the USB cable
turn RevPi power off and on again, wait...
> sudo nmap -sP 10.0.0.*
assuming your local subnet is 10.0.0.xxx
this lists all network devices, which should find also the RevPi
> ssh pi@10.0.0.26
enter serialnumber and mac address and repower your RevPi
search for it on the LAN again:
> sudo nmap -sP 10.0.0.*
> ssh pi@10.0.0.30
for restoring programs and settings proceed with instructions from
https://revolution.kunbus.com/tutorials/overview-revpi-core/install-jessie/