The Industrial Raspberry Pi Forum

Hi,

The RevPi Connect 4 does not boot when I flash the raw disk image of Fedora IoT 40 (aarch64). The device boots to a black screen and it stays black.

In the past, when flashing Fedora IoT on RevPi Core 3 everything worked fine.

Does anyone know a solution?

Thank you,
Gillis

Hi Gillis, well, the Revolution Pi hardware differs from the Raspberry Pi. Thus, you may have to adapt it accordingly, as we do when we're producing our images. Take a look here for an introduction:
https://kunbus-gmbh.atlassian.net/servi ... 3106799722
You can find the circuit diagrams here:
https://revolutionpi.com/en/tutorials/d ... haltplaene
Good luck, you may find support here in the community or in the project if you advertise it.