The Industrial Raspberry Pi Forum

Hi,

I have upgraded from a RevPi Connect to a RevPi connect 4. The image has been upgraded from Stretch to Buster. I know it is not recommended, but I can't reflash as I did not write the original software, so do not know all of the dependancies.

In pictory, I do not have an option for Connect 4. Is it correct to use the "RevPi Connect/+/S" entry? Even when I only have the base in Pictory, I get issues with piTest:

Address: 0 module type: 136 (0x88) unknown moduletype V1.0
Module is present, but NOT CONFIGURED!!!
input offset: 0 length: 6
output offset: 6 length: 7

Address: 31 module type: 103 (0x67) RevPi AIO V1.4
Module is present, but NOT CONFIGURED!!!
input offset: 13 length: 20
output offset: 33 length: 4

Address: 30 module type: 103 (0x67) RevPi AIO V1.4
Module is present, but NOT CONFIGURED!!!
input offset: 37 length: 20
output offset: 57 length: 4

Address: 0 module type: 32873 (0x8069) RevPi Connect V0.0
Module is NOT present, data is NOT available!!!
input offset: 0 length: 6
output offset: 6 length: 5


I am not worried about the AIO modules, I am concerned about the errors on Address 0.
I have reset the driver and cleared Pictory. I have also saved it as start config.

Pictory has been updated to the latest version as far as I know.

Hi,

RevPi Connect 4 support was added with Bullseye, thus won't work with Buster.

Nicolai

Thank you. Will give it a go