Page 1 of 1

Node-red revpi server not working

Posted: 03 Jan 2024, 17:33
by denisds
Hi everyone, I have a problem with using the RevPi DIO module in combination with a Revolupion Pi Connect SE.
I have done all the configuration with Pictory but I can't see via node-red interface the server and its inputs.
All services are enabled (RevPiPyLoad) but from the node I see that it says "disconnected" and from the edit page of the relevant node I cannot see the "Input Pins".
Can anyone help me?
Thanks
DDS
RevPi DIO.png

Re: Node-red revpi server not working

Posted: 04 Jan 2024, 13:39
by u.biakoup
Hello DDS,
I understand you're encountering issues with the RevPi DIO module and Revolution Pi Connect SE in combination with Node-RED. The Problem is the Node-RED Configuration.
Here are some steps to troubleshoot and potentially resolve the problem
  • Double-check the IP address, port, and other relevant settings.
  • The Host must be: localhost
  • the Port must be: 8000
Best Regards,
Ulrich Kouatang Biakoup | Technical Support