ConCAN trouble after upgrading from Connect+ to Connect S
Posted: 20 Nov 2023, 09:53
Hello,
I am using the following Codesys configuration and having problems with the CANbus. Everything runs smoothly on the Connect+. On the Connect S, the CANbus crashes regularly!
Except for the Connect CPU and the buster image installed, the hardware and software are identical. Also the hardware configuration in Codesys!
Image version Connect +: 2021-07-01-revpi-buster.img (running)
Image version Connect S: 2023-01-25-revpi-buster.img (NOT running)
Codesys Version: 3.15.17 Patch 3
RevolutionPiBridge v1.2.0.0
Codesys Runtime 4.4.0.0 (raspberry, armhf) Multicore
Are there any known incompatibilities with the CONNECT S hardware versions?
Is an upgrade to a newer Codesys version, libraries, runtime necessary?
I would be very grateful for any helpful instructions.
I am using the following Codesys configuration and having problems with the CANbus. Everything runs smoothly on the Connect+. On the Connect S, the CANbus crashes regularly!
Except for the Connect CPU and the buster image installed, the hardware and software are identical. Also the hardware configuration in Codesys!
Image version Connect +: 2021-07-01-revpi-buster.img (running)
Image version Connect S: 2023-01-25-revpi-buster.img (NOT running)
Codesys Version: 3.15.17 Patch 3
RevolutionPiBridge v1.2.0.0
Codesys Runtime 4.4.0.0 (raspberry, armhf) Multicore
- RevPi Config.jpg (129.33 KiB) Viewed 7541 times
Is an upgrade to a newer Codesys version, libraries, runtime necessary?
I would be very grateful for any helpful instructions.