CAN Con Problem
Posted: 24 Mar 2023, 14:29
Hello!
I have a setup where I want to connect a sensor via CAN. We have the RevPi Connect and the CAN Con interface.
I have set up everything according the the manual and can see the can0 within the ifconfig view.
However, I do not receive any data packages through the interface.
I assume the handbook is up to date stating CAN_H is on Pin 2 and CAN_L on 3 (the picture on the device states it inverted)
The following troubleshooting has been already done:
- Verification of terminal resistors -> Fine total resistor 60 Ohm (2x 120 Ohm in parallel)
- Measuring the CAN_H and CAN_L just with the sensor in the bus. CAN_H is 3 V, CAN_L is 2 V -> seems like a valid sending of data
- Measuring only the CAN Con interface in the bus - here both CAN_H and CAN_L are 2 V which is strange. Any idea on this?
Any thoughts (German or English) are very much appreciated. Thanks!
I have a setup where I want to connect a sensor via CAN. We have the RevPi Connect and the CAN Con interface.
I have set up everything according the the manual and can see the can0 within the ifconfig view.
However, I do not receive any data packages through the interface.
I assume the handbook is up to date stating CAN_H is on Pin 2 and CAN_L on 3 (the picture on the device states it inverted)
The following troubleshooting has been already done:
- Verification of terminal resistors -> Fine total resistor 60 Ohm (2x 120 Ohm in parallel)
- Measuring the CAN_H and CAN_L just with the sensor in the bus. CAN_H is 3 V, CAN_L is 2 V -> seems like a valid sending of data
- Measuring only the CAN Con interface in the bus - here both CAN_H and CAN_L are 2 V which is strange. Any idea on this?
Any thoughts (German or English) are very much appreciated. Thanks!