The Industrial Raspberry Pi Forum

Hi,

I'm looking for an enclosure for the RevPi & Power Supply.
The Din rail enclosures I found are either too large (width, height) or too shallow to fit the RevPi.

Do you know if such enclosures exist and where I could find them?

Thx in advance.

Hi smannschot,

unfortunately we don't have any suggestions regarding a DIN rail enclosure that just fits a Core and power supply. By our experience, Revolution Pi is usually installed in larger enclosures.

Maybe one of our forums user has a good tip?

Have you tried https://www.bopla.de/en/enclosure-finder.html ?
Do you need it for professional or private usage?

Hi,
In addition to an RevPiCore3, I would like to developp my own network bridge. I like your enclosure design but I would like an additionnal 4-pins connector. So the "maker" version you sold don't fit with my need. Do you share the supplier? is it your own spec? I have seen that Pilz use same design. I have check at Bopla, Phoenix contact. I found some quite good but not perfect as yours.
I will appreciate your advise.
Thanks
Bertrand

Hi Bertrand,
the enclosure is custom made and custom designed. PILZ is a business partner so that is why you find similarities.
Is this for just a view items? If you are planning for a large quantity (at least several hundret per year) we could possibly discuss custom changes. You may contact me via PM to discuss details.

Hi Volker,
Thanks for your feedback.
Congratulation for your custom design : I like it.
I plan for a very low quantity, that's why I am looking for an available solution on the market even with custom machining and labeling.
The most significant item I like is LED light guide on the back side of the pcb. I try to find similar on the market but alwas to big to fit on only 1.6mm...

Thanks again.
Bertrand