Hello,
Can RevPi be used in combination with LabVIEW MakerHub LINX or PROCON-WEB IOT, and if so, are there any related tutorials?
In addition, if I use G Web to develop Web applications, can I use it on RevPi.
Best regards,
Cade
RevPi applications
Hello Cade,
I don't have any idea from LabVIEW MakerHub LINX or PROCON-WEB IOT. Maybe another one from the Forum could write something about that.
About LabVIEW on RevPi:
Our RevPI does not support LabVIEW LINX from my knowledge. The issue was, that they build their software using the Raspberry Pi Kernel tooling. We have a different Kernel running on our RevolutionPI. In conclusion, we can offer you nothing from out of the box. Since NI offers a runtime for LabVIEW on Linux, there might be some workaround. I guess some deeper Linux <-> LabVIEW Knowledge is necessary to get things running, which we at KUNBUS do not have.
Another workaround could be communication with TCP/IP between LabVIEW <-> RevPI
Take a look here
Best Regards
Ulrich Kouatang Biakoup | Technical Support
I don't have any idea from LabVIEW MakerHub LINX or PROCON-WEB IOT. Maybe another one from the Forum could write something about that.
About LabVIEW on RevPi:
Our RevPI does not support LabVIEW LINX from my knowledge. The issue was, that they build their software using the Raspberry Pi Kernel tooling. We have a different Kernel running on our RevolutionPI. In conclusion, we can offer you nothing from out of the box. Since NI offers a runtime for LabVIEW on Linux, there might be some workaround. I guess some deeper Linux <-> LabVIEW Knowledge is necessary to get things running, which we at KUNBUS do not have.
Another workaround could be communication with TCP/IP between LabVIEW <-> RevPI
Take a look here
Best Regards
Ulrich Kouatang Biakoup | Technical Support
