RevPi Core S and new image problem

[laura]

Hi,
after performing the steps mentioned in the video tutorial 01 , as well as follow the procedure mentioned on https://revolutionpi.com/tutorials/imag ... d-stretch/ , my router has stopped doing the blink of the ethernet port thus preventing access to the IP.
Furthermore in the USB connection , no memory is recognized but also boot(E:).
How can I solve these problems?

Thank you.

[nicolaiB]

Hi Laura,

I'm not 100% sure that I understood what your problem is, so let me rephrase it: You flashed a RevPi Core S like shown in our video tutorial. Were there any error messages or went everything succesfull? A often made mistake is to forgot to remove the micro USB cable after flashing the device. If the cable is present the internal USB controller is disabled and also the device does not boot.

Nicolai

[laura]

Hi Nicolai,
you understood perfectly!
Firstly appeared the (F:) drive formatting pop up but I ignored it.
Secondly I did the formatting , then I flashed a RevPi Core S like shown in video tutorial.

[nicolaiB]

So, I understand that your problem is, that the RevPi does not boot after a image was flashed succesfully? If yes, please check if the micro usb cable was removed after flashing it. If you connect a monitor to the HDMI port, are there any (error) messages?

Nicolai

[laura]

GM Nicolai,
here's the picture!

[nicolaiB]

Looks like the image was not flashed succesfully / incomplete. Could you please try again?

[laura]

I tried but the problem is that only drive (E:) is recognized

[nicolaiB]

That should not matter at all.

Nicolai