Page 1 of 1

imaging failed to proceed around 26%

Posted: 06 Oct 2022, 04:51
by kwang
Hello there,

I have a 32G RevPi Connect+ on which I was trying to load the 2022 05 25 revpi buster image through the win32diskimager, but kept failing around 25%.
power reset didn't help either and screen capture uploaded as blow: Image

would you help to figure out what the problem is pls?

Re: imaging failed to proceed around 26%

Posted: 06 Oct 2022, 11:27
by nicolaiB
Maybe the wire, which disables the hardware watchdog is missing on connector X4?

-Nicolai

Re: imaging failed to proceed around 26%

Posted: 06 Oct 2022, 12:27
by u.biakoup
nicolaiB wrote: 06 Oct 2022, 11:27 Maybe the wire, which disables the hardware watchdog is missing on connector X4?
For more Information see here https://revolutionpi.com/tutorials/uebe ... g-connect/

Best Regards

Ulrich Kouatang Biakoup | Technical Support

Re: imaging failed to proceed around 26%

Posted: 07 Oct 2022, 02:44
by kwang
jumper cable is in as pic shows.
Image

and with this same cable I have imaged the other one, on the left side in picture for many times, no any issue with it

Re: imaging failed to proceed around 26%

Posted: 07 Oct 2022, 10:20
by u.biakoup
Hallo Kwang,
I have some instructions for you.

Please use the software balenaEtcher instead of Win32DiskImager.
https://www.balena.io/etcher/
We have a new Image from 08/2022 on our homepage. You can fash it on your Device: https://revolutionpi.de/tutorials/downloads/
Maybe make sure you are using anew version of RPI Boot.
We have a Revolution Pi RPI Boot Checklist

Best Regards

Ulrich Kouatang Biakoup | Technical Support

Re: imaging failed to proceed around 26%

Posted: 11 Oct 2022, 02:53
by kwang
balena didn't work either.

any idea about the root cause?

Re: imaging failed to proceed around 26%

Posted: 13 Oct 2022, 13:40
by u.biakoup
Hello Kwang,
Have you tried with another wire?
The same problem occurs when the wire is nit stable or defective.
please try with another wire.

Best Regards

Ulrich Kouatang Biakoup | Technical Support

Re: imaging failed to proceed around 26%

Posted: 14 Oct 2022, 02:26
by kwang
tried with diffrent usb cables, power reset my pc, etc.

Re: imaging failed to proceed around 26%

Posted: 14 Nov 2022, 15:03
by u.biakoup
Hi Kwang,
Could you try with another pc? If the problem is RPI-BOOT. Please have a look on Revpi Boot checklist.

Best Regards

Ulrich Kouatang Biakoup | Technical Support