Page 1 of 1

Revpi connect leds and relay only pulse

Posted: 03 Aug 2022, 16:28
by S_wauters
I am using the revpi connect with codesys.
I can control led A2 trough the revpiled byte as expected ( red & green ).
However A1, A3 and the relay on X2 only give a short pulse on the rising edge signal of the according revpiled bit.

In codesys the bit stays in the condition i set it at and forcing it does not change the behavior.

signal :___,-----,__,-----,____
led :___I______I_______
relay :___I______I_______

i would like to use the relay on the X2 for shutdown indication so correct behavior is important.

What would be causing this behavior?

Re: Revpi connect leds and relay only pulse

Posted: 25 Aug 2022, 09:12
by giuseppe
Hello,

we are not familiar with this behaviour. I have just tried this with our latest image and it all worked.
I have tried this with codesys and piTest.

Please follow the checklists below.

RevolutionPi Checklist
Codesys Checklist

I hope this will solve your problem.