The Industrial Raspberry Pi Forum

Hello, I'm having trouble collecting the variables from the inverters toshiba VFS15 using modbus rtu.
The configurations are all made, I've pre setted everything, but when using node red , the variables I receive are random and make absolutely no sense. When I connect via cabel the values we measure are in the following image, but those do not correspond to the values I reveice in mod bus. I used the Qmodmaster tool to get the variables numbers before connecting to the revolution Pi. The values are shown above. After configurating the rev Pi with the same configuration as modMaster the values are different, they do not match.
this is the value that shows up with the same ocnfigurations when we use the RevPi Does anyone know why this happens or how to fix this?

I can see that your system is not up to date (pictory 2.0.4). Please install the latest updates via the package manager (sudo apt-get update && sudo apt-get upgrade). After the update please restart your system and create a fresh pictory configuration. There were several fixes regarding modbus and the virtual devices which might resolve your problems.

Nicolai

we did the uptade and rebooted the revpi... but the values we are receiving are not correct .

hey again. we tried to read the input word 1, and the results were the following we think we are not receiving any kind of information, not data is coming to input word1.

Can you help us?

Did you also, as I suggested, cleared the pictory configuration and configured the modbus module from scratch?

Nicolai