The Industrial Raspberry Pi Forum

Dear All,

Reading about the galvanic isolation on the AIO data sheet, I gather that I can use the GND pins for the analog inputs interchangeably. I'd rather not have to run a bundle of parallel wires all carrying the same signal, if I don't need to.

So in a simple system, I should be able to have a single GND connection for all inputs, plus a single GND connection for all outputs. Is that correct?

Kees Jan

Hi Kees,

the analog inputs are differential and therefore do not have a common signal ground. Connecting all the signal ground together may work but haven't been tested by us thus the function can be guaranteed. Please also note that with this wiring you might lose accuracy and the other benefits of the differential transmitter. Also keep in mind that the supply ground must be separated from the signal ground in any cases.

Nicolai

Dear Nicolai,

Thank you for explaining. I see now that my question does not really make sense. It's been too long since I worked with electronics.

Kees Jan