The Industrial Raspberry Pi Forum

Hi,

Having some trouble with understanding the Analogue outputs on the Revolution Pi Compact.

I am unable to see any option to set the parameters for the outputs in Codesys

Also using piTest I tried setting a value

PiTest -w Aout_1,27648
"Write value 27648 dez (=6c00 hex) to offset 25"

But when I read the output

PiTest -r AOut_1

It shows:

2 Byte-Value of AOut_1: 80 dez (=0050 hex)

Hello,

there is a post in the RevPi forum that is similar to your question. see in the link below.
viewtopic.php?t=3377

I hope I could help you with your problem

Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support