The Industrial Raspberry Pi Forum

Hello,

We have some problems with the input signals from the DIO/RevPi.
We are using RevPi Core 3 and a DIO module.

The problem is occasionally (once per 2 months) we are not receiving any imput signals - I'm not sure what's the cause ATM.
The solution is to do a `sudo reboot`, and afterwards everything works again.

Today I tried to do a firmware upgrade to the DIO module, but it was already on the latest version (1.6).

So, my question: What are this bits for and I'm wondering if I can use them to do a sudo reset if something is wrong: RevPiStatus, RevPiIOCycle and a DIO Status?

Thanks in advance

Hi,

where did you get the 1.6 firmware version? The latest version is 1.5, which is also shipped with our modules.

Nicolai

I think this was written after trying to do the update. Maybe I've misread

Dear toklobuc,

- additionally we would need more info about the set-up e.g. picture, video and description
- SOS report would be great: https://kunbus-gmbh.atlassian.net/servi ... 2036400208

Thanks, Julian

OK thank you.

Our setup is RevPi Core 3 + a DIO module on 3A PS.

I will send the SOS report after another "freeze" because yesterday I installed a fresh OS