Page 1 of 1
Low Power Mode
Posted: 25 Nov 2021, 01:55
by jrileycaban
Does the RevPi Connect+ have a low power mode? If so, what is the max current draw in this mode? Specifically I am looking for the maximum current expected at turn-on.
Thank you for your help,
Jessica
Re: Low Power Mode
Posted: 30 Nov 2021, 11:00
by ->Johannes<-
Dear Jessica,
Does the RevPi Connect+ have a low power mode? If so, what is the max current draw in this mode?
No, there is no low power mode.
Specifically I am looking for the maximum current expected at turn-on.
I have just started a Connect, at 24 V it ran up to approx. 0.21 A at start-up and has settled at 0.15 A.
However, this also depends on your setup.
Our documentation gives the following values:
Max. power consumption 20 Watt (incl. 1 A total USB output current) --> The average power consumption without USB load varies greatly and depends on the use of the interfaces, the GPU and the CPU. It is usually well below 4 watts without HDMI.
Please check
RevPi Connect+ Datasheet
regards
Johannes
Re: Low Power Mode
Posted: 30 Nov 2021, 20:16
by jrileycaban
Thank you very much for the information - this is helpful.
Could you tell me if the current changes if running off of a 12V supply?
Thanks again!
Jessica
Re: Low Power Mode
Posted: 02 Dec 2021, 11:38
by ->Johannes<-
Dear Jessica,
Could you tell me if the current changes if running off of a 12V supply?
yes, the current will increase.
Regards
Johannes