The Industrial Raspberry Pi Forum

Hello,
I am using RevPi Core 3 with Profinet Gateway IRT module connecting with Siemens PLC. I can configure and connect Profinet with PLC fine. But when I restart RevPi overnight, the Profinet IP go back to 0.0.0.0 and cannot connect with my PLC anymore. I need to config Profinet again. However, if I restart RevPi for a few minutes, the Profinet work fine.

May you suggest how to make the Profinet IP does not go back to 0.0.0.0?

Hi supot,

can you please share some information in order to investigate the problem?

• Image version of your RevPi
• Firmware version of the gateway
• Kernel log file

Nicolai

Hello Nicolai,
Thank you for your reply. let me check this information and get back to you.