EtherCat Gateway Config
Posted: 12 Oct 2021, 10:12
Hi,
I'm having trouble configuring the Ethercat gateway and need some assistance!
- The gateway is positioned as the outer module [Ethercat][Core3][AIO]
- I've set this in Pictory and saved in as start config.
downloaded the ESI file from the Kunbus website and uploaded it to the master (Trio Motion Flex6 Nano)
during pre-op I get "SDO abort (value range of parameter exceeded only for write access)"
(This is my first time in the "Ethercat Club" please be gentle)
Its got to be the configuration of the gateway in the master if anybody has any information on the configuration I would be extremely grateful
I'm having trouble configuring the Ethercat gateway and need some assistance!
- The gateway is positioned as the outer module [Ethercat][Core3][AIO]
- I've set this in Pictory and saved in as start config.
downloaded the ESI file from the Kunbus website and uploaded it to the master (Trio Motion Flex6 Nano)
during pre-op I get "SDO abort (value range of parameter exceeded only for write access)"
(This is my first time in the "Ethercat Club" please be gentle)
Its got to be the configuration of the gateway in the master if anybody has any information on the configuration I would be extremely grateful