The Industrial Raspberry Pi Forum

Posted: **05 Oct 2021, 11:37**

Hello,
I have a fresh instalaltion of a revpi connect + with DIO, DI and CON CAN modules.
I COnfigured all devices once but I could not have the DI module working.
So I wanted to update the firmware, and when I removed the other devices and set the new configuration in pictory I had the following message

ressources/data/patterns/export/project.json: required JSON file not available or invalid!

The configuration is not saved and when I type piTest -d to get the devices I have:

Code: Select all

Found 2 devices:

Address: 0 module type: 105 (0x69) RevPi Connect V1.0
Module is present
     input offset: 0 length: 6
    output offset: 6 length: 5

Address: 31 module type: 97 (0x61) RevPi DI V1.5
Module is present, but NOT CONFIGURED!!!
     input offset: 11 length: 70
    output offset: 81 length: 18

I tried to remove completely and reinstall pictory but it's not worked.

I'm using the stretch release

regards

Posted: **05 Oct 2021, 13:52**

problem solved after several manipulations. I don't know which one worked.
I removed the file /var/www/pictory/projects/_config.rsc , removed the cache from the browser and reinstall completely pictory without logiclab

Posted: **11 Oct 2021, 13:28**

Hi siden,

It is good to hear that you have solved your problem.
Do you want to stay on Stretch, because Buster has also been released for some time.

Regards
Johannes

The Industrial Raspberry Pi Forum

pictory does not save config

pictory does not save config

Re: pictory does not save config

Re: pictory does not save config