We are using our RevPi Connect+ which has a HW watchdog installed on it. After removing the jumper on it the equipment is running ok and the watchdog works perfectly (if we do not toggle watchdog after a while it reboots).
According to the documentation on watchdog available by Kunbus it is supposed that the watchdog reboots the equipment after 60 seconds. We are experience considerably larger time (150-200 seconds).
Can you please advise? Is this time somehow configurable?
Thanks in advance
Watchdog
Hello aas, yes this is a known fact. Have a look at this post - just use a translator like deepl.com:
viewtopic.php?f=4&t=2479&p=9123&hilit=watchdog#p9123
viewtopic.php?f=4&t=2479&p=9123&hilit=watchdog#p9123
Hi, now it is available in English language in our Knowledge Base:
https://kunbus-gmbh.atlassian.net/servi ... 1058439239
"The hardware watchdog time on the RevPi Connect is different when switching on the system, right?"
You just have to register with your E-Mail address to access it.
The registration page is currently in German language only so here is a short animation how it works:
https://kunbus-gmbh.atlassian.net/servi ... 1058439239
"The hardware watchdog time on the RevPi Connect is different when switching on the system, right?"
You just have to register with your E-Mail address to access it.
The registration page is currently in German language only so here is a short animation how it works:
- Attachments
-
- Video.JSD.Registration GIF.gif (755.56 KiB) Viewed 2383 times
