Question about DIO output
Posted: 11 May 2021, 12:59
Hello,
I am working on a project where I control two frequency inverters Mitsubshi FR-D700 and Hitachi WJ200. I have attached input description of both inverter, both inverter are configured with sourcings inputs.
I have a 24v external power supply connected on X2 connector. I am using O1 and O2 to drive FR-D700 inverter and O3 and O4 to drive WJ200 inverter. power supply GND is connected to pin SD and L of inverter (internal GND).
When the output are configured in High-side mode i have the following behavior : when I am driving WJ200 inverter I have also a current flowing into FR-D700 even if there related output are low.
The issue is solved if I am using push-pull mode.
Can you explain me why I have this behavior? Why current is flowing in O3-O4 when they are in high impedance state while O1 or O2 is in high state.
Let me know if my problem is clear or not, I can make a schematic connection diagram if required
I am working on a project where I control two frequency inverters Mitsubshi FR-D700 and Hitachi WJ200. I have attached input description of both inverter, both inverter are configured with sourcings inputs.
I have a 24v external power supply connected on X2 connector. I am using O1 and O2 to drive FR-D700 inverter and O3 and O4 to drive WJ200 inverter. power supply GND is connected to pin SD and L of inverter (internal GND).
When the output are configured in High-side mode i have the following behavior : when I am driving WJ200 inverter I have also a current flowing into FR-D700 even if there related output are low.
The issue is solved if I am using push-pull mode.
Can you explain me why I have this behavior? Why current is flowing in O3-O4 when they are in high impedance state while O1 or O2 is in high state.
Let me know if my problem is clear or not, I can make a schematic connection diagram if required