Page 1 of 1

AIO input doesn't work after few restart

Posted: 04 Feb 2021, 09:41
by ivan.chonin@axbul.bg
Hello,
We work with Codesys on Revpi core 3, DIO and AIO . On Codesys we actully do the same setup as in Pictory. First question is: Do we have to set up Pictory and Codesys with the same settings?
We realised that after some restart of the system one of the input of the AIO doesnt work while the other input works. When we enter the Pictory and after few "reset driver" it start showing again.

What can be the reason ?

Re: AIO input doesn't work after few restart

Posted: 08 Feb 2021, 10:41
by ->Johannes<-
Hi Ivan,

please have a look to this topic.
Trouble getting through the "Integrate RevPi into CODESYS" tutorial

If problems persist, please let us know so we can support you.

Regards

Johannes

Re: AIO input doesn't work after few restart

Posted: 08 Feb 2021, 13:12
by ivan.chonin@axbul.bg
Hello,
I Already went thru the new datasheet. Still cannot find the answeron this:
Should we set up the configuration on Pictory AND Codesys or only on Codesys ?

Re: AIO input doesn't work after few restart

Posted: 10 Feb 2021, 13:28
by ->Johannes<-
Hi,
It is enough to set up the configuration in Codesys.
If you still have problems, please contact me again.

Best regards

Johannes