Page 1 of 1

RevPi Connect Dead Ports

Posted: 07 Oct 2020, 17:34
by Ibrahim Stracey
Hi everyone,

I'm experiencing some issues with my RevPi Connect. I plugged in a USB hub which seemed to cause a short-circuit. I immediately disconnected everything. I turned it back on and the status lights (PWR,WD, and REL) all go green, but all the ports are dead. Would the status lights still come on if there was damage to the processor itself? I'm not sure how to go about troubleshooting this.

Regards,

Ibrahim

Re: RevPi Connect Dead Ports

Posted: 08 Oct 2020, 09:25
by dirk
Dear Ibrahim, so in this case we have to analyze your device here in order to find the root cause of the error. I'll contact you via EMail.