RevPi Connect - Webpage/Connection Error
Posted: 07 Aug 2020, 10:09
Hello all,
Is there an error on the RevPi Connect page (https://revolution.kunbus.com/tutorials ... i-connect/) showing the orientation of the PiBridge/Connect links (3)/(5)??
The illustration shows the top of the module (with the module front at the bottom of the illustration) & says that (3) the PiBridge Connector (shown on the RIGHT HAND SIDE of the illustration ) ..... must be connected to the expansion modules .....on the left hand side.
Conversely, the description for the 'Connect' connection (5) (on the left-hand side!) describes its modules being connected on the right-hand side.
It looks as if (3)/(5) have been flipped on this diagram.
Can someone please check/confirm/correct the webpage?
Thanks,
PT.
Is there an error on the RevPi Connect page (https://revolution.kunbus.com/tutorials ... i-connect/) showing the orientation of the PiBridge/Connect links (3)/(5)??
The illustration shows the top of the module (with the module front at the bottom of the illustration) & says that (3) the PiBridge Connector (shown on the RIGHT HAND SIDE of the illustration ) ..... must be connected to the expansion modules .....on the left hand side.
Conversely, the description for the 'Connect' connection (5) (on the left-hand side!) describes its modules being connected on the right-hand side.
It looks as if (3)/(5) have been flipped on this diagram.
Can someone please check/confirm/correct the webpage?
Thanks,
PT.