Page 1 of 1

i2C configuration

Posted: 26 Nov 2019, 15:13
by GrandinHippolyte
Hello,

I'm a french engineering student.
I'm a project and I need to use a Raspberry. The solution of RevPi interest me.
I need 1 analog input (0-10v) et 2 analog output (0-10v), and 1 RTD, so the Analog I/O Module is OK.

But need to use an accelerometer with I2C. Do you have a solution for this ?

Thanks,
Hippolyte

Re: i2C configuration

Posted: 28 Nov 2019, 12:59
by dirk
Hi Hippolyte, yes the AIO Module can handle this requirement. But there is unfortunately no I2C interface available on the RevPi Connect or RevPi Core Modules.

Re: i2C configuration

Posted: 17 Dec 2020, 12:47
by mglowinski93
Can DIO module handle I2C communication? If yes, is there some document with description how to do this?

Re: i2C configuration

Posted: 18 Dec 2020, 10:22
by Amar
There is no direct interface provided by DIO module over the piBridge.
You can refer to following posts for further information:

https://revolution.kunbus.com/forum/vie ... 1c45#p5416

https://revolution.kunbus.com/forum/vie ... 1c45#p3046