Page 1 of 1

Target visu or displaying the webvisu from the HDMI output

Posted: 26 Sep 2019, 12:59
by raydodo
Hi

I would like to connect the HDMI output of the RevPi to a local screen and display the webvisu. I have seen some older posts stating this is possible, but I have tried with no success. See: https://forum.codesys.com/viewtopic.php?t=6077

Has anyone done this with a RevPi or could they assist?

UPDATE: I have enabled the "Boot to GUI" option on the RevPi - still can't see any screen though...

Thanks

Ray

Re: Target visu or displaying the webvisu from the HDMI output

Posted: 30 Sep 2019, 14:43
by dirk
Hi Ray, can you see a HDMI output on the screen without using Codesys? Are you able switch the resolution i.e. with the "revpi-config" tool?