Revpi Core PiSerial Failure and Communication issue

[Zenbe]

Hi Revpi Team,

I have two Revpi Core 3. On one revpi, when I load a new image on it and enter its serial and its Mac address, it gives me this :

Capture1.PNG (8.26 KiB) Viewed 4161 times

Second issue, on the two Revpi, I'm not able to communicate with AIO module even if this one is well configured in Pictory and plugged. The power LED keeps blinking red

Capture.PNG (10.02 KiB) Viewed 4161 times

I hope we can solve the problems.

Thank you in advance

[dirk]

Dear Zenbe,
please update the "piserial" package and try it again please. It looks like this similar problem unfortunately in German language.

Code: Select all

sudo apt update 
sudo apt install piserial

The AIO communication problem may be caused by the switching latency of the power supply.
The power supply from our shop has a latency of about 5 ms which works perfect.
Please check your power supply latency i.e. with an oscilloscope or try to use one from our shop.

[Zenbe]

Dear Dirk,

Thanks for your reply. Unfortunately, even after upgrading piSerial, issue is still there.
Concerning communication with AIO, i tried with three others power supply of which one was already used with revpi 6 months ago, but the result was the same.

Do you have other ideas to solve these problems?

[dirk]

Dear Zenbe, please excuse the long delay. I'll send you an RMA.

[Zenbe]

Dear Dirk,

No problem for the long delay. Thanks for the RMA.