Page 1 of 1
How many RevPi Con CAN modules can be connected?
Posted: 27 Apr 2019, 12:09
by abisysa
I would like to know how many RevPi Con CAN expansion modules can be connected to RevPi Connect?
Re: How many RevPi Con CAN modules can be connected?
Posted: 02 May 2019, 10:11
by lukas
Only a single Con CAN module may be attached.
However one Con CAN module and one M-Bus module can be used simultaneously.
Re: How many RevPi Con CAN modules can be connected?
Posted: 03 May 2019, 08:34
by abisysa
Do you have any recommendations or suggestions to control 2 CAN bus in a Kunbus raspberry pi environment?
Re: How many RevPi Con CAN modules can be connected?
Posted: 10 May 2019, 11:15
by dirk
You may use a Con CAN Module and a USB-CAN interface see here
elinux.org/CAN_Bus
Re: How many RevPi Con CAN modules can be connected?
Posted: 05 Mar 2021, 12:23
by DominikEngl
Is it possible to use a PEAK-USB CAN Device ?
Re: How many RevPi Con CAN modules can be connected?
Posted: 23 Jun 2023, 16:37
by dirk
Thuy, unfortunately, this is due to technical reasons, see circuit diagram of the Revolution Pi Compact.
https://revolutionpi.com/tutorials/down ... haltplaene
Furthermore, the Con-Bridge is no longer implemented on CM 4 modules.
Re: How many RevPi Con CAN modules can be connected?
Posted: 30 Jun 2023, 11:25
by nicolaiB
Yes, the 1 CAN module limitation applies to all Connect variants (RevPi Connect / Connect + / Connect S / Connect SE). Unfortunately there is no device which supports more than that.
Nicolai