Changing Baud rate in Pictory results in missing extended data

[ChrisDeveloper]

Hi There,

I copied a _config file from one kunbus connect + to another and when I changed the baud rate or used any of the rs485 drop down settings parts of the Extended Data where lost.

In order to change the baud rate and parity, I had to manually edit it in a text editor.

Please see attached Screenshots.

Kind regards,
Chris

[dirk]

Hi Chris, thank you for your patience. I have made a test setup that included a RevPi Connect with a Modbus RTU Mater.

PiCtory devices

2020-12-10 17_53_50-image-20201210-164117.jpg (28.69 KiB) Viewed 2937 times

Baud rate etc.

2020-12-10 17_54_03-image-20201210-164132.jpg (21.24 KiB) Viewed 2937 times

Extended data

2020-12-10 17_53_31-image-20201210-164101.jpg (52.67 KiB) Viewed 2937 times

• I have performed some example extended data configurations.
• Then I have saved the configuration as default
• I copied the configuration it to another RevPi Connect
• changed the baudrate
• saved the configuration as default
• verified if the extended data changed

I was unable to reproduce the errorenous behavior.

My ideas on this:

• Please check the PiCtory versions
• Delete the browser cache

PiCtory acts like a diva here sometimes so please excuse this.