RevPi Con CAN datasheet layout mismatch

Bertrand · Post by **Bertrand** » 24 Sep 2020, 17:45

Hi,
May be already related in this forum but I don't find it, there is a mis match between the layout of X2 in the datasheet and the module silfscreen.
Datasheet CANH in port 3, in the module CANH is in port 2.

Bertrand

Post by **dirk** » 06 Oct 2020, 08:36

Hi Bertrand, unfortunately we made a mistake here the cases are obviously wrongly lasered.
I will reply you when I have news for you.

Bertrand · Post by **Bertrand** » 30 Nov 2020, 14:07

Once again,
today, I powered a module with a sticker (covering the laser schematic).
The sticker indicate CANL on X2 port 2 (like a new module received some days ago).
But, the sticker is wrong. The module have CANL on port 3.

Bertrand

Post by **dirk** » 07 Jan 2021, 10:57

Hi Bertrand, I am sorry for the troubles you are having hereby. Thank you for your feedback and the constructive reply. This helps us a lot.
We have to review this internaly and reply to you as soon as possible. Thank you for your patience.

Post by **dirk** » 15 Jan 2021, 15:44

Hi Bertrand, we have discussed this again with all stakeholders - the signal lines and the sticker represents the following:

CAN_L - PIN 2
CAN_H - PIN 3

RevPi Con CAN datasheet layout mismatch

Products

Ordering

Support

Company