Hi,
May be already related in this forum but I don't find it, there is a mis match between the layout of X2 in the datasheet and the module silfscreen.
Datasheet CANH in port 3, in the module CANH is in port 2.
Bertrand
RevPi Con CAN datasheet layout mismatch
Re: RevPi Con CAN datasheet layout mismatch
Hi Bertrand, unfortunately we made a mistake here the cases are obviously wrongly lasered.
I will reply you when I have news for you.
I will reply you when I have news for you.
Re: RevPi Con CAN datasheet layout mismatch
Once again,
today, I powered a module with a sticker (covering the laser schematic).
The sticker indicate CANL on X2 port 2 (like a new module received some days ago).
But, the sticker is wrong. The module have CANL on port 3.
Bertrand
today, I powered a module with a sticker (covering the laser schematic).
The sticker indicate CANL on X2 port 2 (like a new module received some days ago).
But, the sticker is wrong. The module have CANL on port 3.
Bertrand
Re: RevPi Con CAN datasheet layout mismatch
Hi Bertrand, I am sorry for the troubles you are having hereby. Thank you for your feedback and the constructive reply. This helps us a lot.
We have to review this internaly and reply to you as soon as possible. Thank you for your patience.
We have to review this internaly and reply to you as soon as possible. Thank you for your patience.
Re: RevPi Con CAN datasheet layout mismatch
Hi Bertrand, we have discussed this again with all stakeholders - the signal lines and the sticker represents the following:
- CAN_L - PIN 2
- CAN_H - PIN 3
- Attachments
-
- grafik-20210107-100203.png (65.68 KiB) Viewed 4138 times