Cannot read the drive letter with Revpi connect
-
- Posts: 30
- Joined: 03 Sep 2018, 10:01
Cannot read the drive letter with Revpi connect
Dear sir ,I Use RPIboot to read and write the image of RPI connect, cannot read the drive letter,I can't find the drive letter, but read and write Revpi core 3 is ok,use rpiboot with Revpi core 3,I can find Drive letter(F:/),Why not Revpi Connect?
Re: Cannot read the drive letter with Revpi connect
Hi huanghuapan, have a look at the FAQs here - did you try this?
-
- Posts: 30
- Joined: 03 Sep 2018, 10:01
Re: Cannot read the drive letter with Revpi connect
Yes, I did.I installed the driver, but I still can't find the drive letter after executing rpiboot, but I can find the drive letter of the core 3 module through the same operation, but Connect doesn't work,I don't know why,Is there any other way?
-
- Posts: 30
- Joined: 03 Sep 2018, 10:01
Re: Cannot read the drive letter with Revpi connect
sorry,for this problem,Do you have some way to slove?
Re: Cannot read the drive letter with Revpi connect
Dear huanghuapan, we have to examine the device. I have contacted you via EMail.
-
- Posts: 30
- Joined: 03 Sep 2018, 10:01
Re: Cannot read the drive letter with Revpi connect
Dear Dirk,
Regarding the RevPi Connect +16G module you repaired(SUP-1542) before, the customer found that the mirco HDMI interface was crooked after receiving it. So the customer disassembled and corrected it, then plugged in the cable, and pulled out the entire Mirco HDMI interface module when unplugging the cable.Attach relevant pictures.
1.Did you disassemble this product during repairs before? After receiving it, the customer reported that the Mirco HDMI interface could not be plugged in, and the interface was incorrect.
2.Now the customer has broken the Mirco HDMI interface, what solution do you have here?Can you give some suggestions?
Looking forward to your reply,thank you.
Regarding the RevPi Connect +16G module you repaired(SUP-1542) before, the customer found that the mirco HDMI interface was crooked after receiving it. So the customer disassembled and corrected it, then plugged in the cable, and pulled out the entire Mirco HDMI interface module when unplugging the cable.Attach relevant pictures.
1.Did you disassemble this product during repairs before? After receiving it, the customer reported that the Mirco HDMI interface could not be plugged in, and the interface was incorrect.
2.Now the customer has broken the Mirco HDMI interface, what solution do you have here?Can you give some suggestions?
Looking forward to your reply,thank you.
- Attachments
-
- 2.jpg (99.05 KiB) Viewed 7180 times
-
- 1.jpg (309.93 KiB) Viewed 7180 times
Re: Cannot read the drive letter with Revpi connect
Dear huanghuapan, I am sorry to hear that from you. I'll clarify this as soon as possible. Please excuse the troubles that you have.