Hi there,
I have just been put on track of RevPi on the SPS today in nuremberg as we have prototyped a commercial product with plain raspberryPi now thinking of getting ready to transform the prototype to a more official release version of a commercial product.
Part of the RapberryPi setup uses a "4-Kanal 5V Relais Modul Optokoppler Relay Low Pegel Arduino Raspberry Pi" as for instance can be seen on here https://www.ebay.de/i/162681155526?chn=ps. My question now is: How to ideally transform this to some RevPi-Modul? So far i didnt see a Relais Modul of RevPi that could "switch on / off" 230V by an internal digital high or low.
Thank you very much in advance. In case more details are necessary I am happy to provide more information.
RevPi - Opto-Coupler - Relais Modul!!
Re: RevPi - Opto-Coupler - Relais Modul!!
Hi no we don't offer such relais. Have a look here for example: https://www.digikey.de/short/zpwrct
Then you just switch the relais using a RevPi Core 3/+ or RevPi Connect/+ Module plus a DO or a DIO Module.
The difference here is that the RevPi uses a process image rather than GPIOs to switch the output pins.
Have a look at Video Tutorial 12 – Digital IO Modules application example
Then you just switch the relais using a RevPi Core 3/+ or RevPi Connect/+ Module plus a DO or a DIO Module.
The difference here is that the RevPi uses a process image rather than GPIOs to switch the output pins.
Have a look at Video Tutorial 12 – Digital IO Modules application example