Hello, I have a RevPiCore 3 and a AIO module.
I was trying to test my AIO, So I make the chain like this
Revpicore <-> AIO (with PiBridge, PowerSupply well)
In the initial status, The result of piTest -d was like this (Before handling pictory)
Found 2 devices:
Address: 0 module type: 95 (0x5f) RevPi Core V1.2
Module is present
input offset: 0 length: 6
output offset: 6 length: 5
Address: 32 module type: 103 (0x67) RevPi AIO V1.3
Module is present
input offset: 11 length: 20
output offset: 31 length: 4
After configuring the Core and AIO with Pictory and Save file, Reset Driver,
the result of piTest -d was like this
Found 2 devices:
Address: 0 module type: 95 (0x5f) RevPi Core V1.2
Module is present
input offset: 0 length: 6
output offset: 6 length: 5
Address: 32 module type: 32871 (0x8067) RevPi AIO V0.0
Module is NOT present, data is NOT available!!!
input offset: 11 length: 20
output offset: 31 length: 4
I can't handle this problem..
What's wrong with this??
Can't config my AIO module..
Re: Can't config my AIO module..
Hello Kimsehwan, does this problem still exist?