I have RevPi Core3 with DIO and AIO modules.
During completion of our project, the problem with AIO module start-up appeared.
After power-on (after long period in the off state) the module stays in the phase when red power LED is blinking and is not detected by the Core unit.
Software reboot of the core does not help.
After powecycling the 24V/45W supply the module works normally.
The configuration and firmware version of the modules:
Code: Select all
Address: 0 module type: 95 (0x5f) RevPi Core V1.2
Module is present
input offset: 202 length: 6
output offset: 208 length: 5
Address: 31 module type: 96 (0x60) RevPi DIO V1.4
Module is present
input offset: 89 length: 70
output offset: 159 length: 18
Address: 30 module type: 103 (0x67) RevPi AIO V1.3
Module is present
input offset: 0 length: 20
output offset: 20 length: 4
Address: 64 module type: 24580 (0x6004) ModbusRTU Master Adapter V0.0
Module is present
input offset: 213 length: 101
output offset: 314 length: 75