It looks like that the part were the bus connector is located is somewhat shifted by a fraction of a millimeter. Maybe it is some rounding errors (the rest looks fine though, so I doubt it), but it leads to a non-continues outline and my PCB manufacturer will refuse to mill the contour with those broken outline data.
- PCB Contour Issues.png (34.03 KiB) Viewed 5118 times
Can someone re-check this and maybe update the DXF once more please? There is a comment made here viewtopic.php?f=16&t=139 that the DXF was already modified but to me it looks still not 100% accurate. Maybe also suggestions on drill diameters for the connectors can be added (I measured them already, just since the drawing needs to be touched anyhow it may be of help for other people).
And can someone enlighten me what the red marked hole is used for? It sits somewhere in the lower part of the orange front cover but I cannot find any matching pin in the plastic housing so I was wondering if that is really needed?
Otherwise the Makerkit looks really cool and I'm looking forward for my first custom module!
Markus
