Hi, I am trying to use a Rev Pi Connect with a Kunbus Serial Gateway module. I am having trouble getting it to read RS232. I have it connected and configured the module correctly. I have tried setting it up using the PiCtory software but when i try add the card "Gateway Serial" using the software I get an error that reads "ERR_EXCLUDED_DEVICE_PRESENT: [id^='device_RevPiGate']". I have a RevPi Connect and a RevPi Con CAN module in the software aswell, couId this be causing my error, or do I need to use a RevPi Core with this module?
Thanks
Ryan
Kunbus Serial Gatreway
Dear Ryan, the RevPi Gate Serial Slave needs to have a script defined by you in order to. To load scripts onto the RevPi Gate Serial, this USB-PiBridge Plug (Item-No.: 100101) is mandatory. The software is called KUNBUS Scripter free available here: https://www.kunbus.com/downloads.html There are examples scripts in the user manual which you can find on the same page. This is necessary because the serial protocol just defines bytes and not data frames. So if you want to interpret a line like "123.45\r\n" as a data set you have to write a script according to that application. Regarding the error in PiCtory I am not sure how this may happen. But I will review this in the team. The configuration of your module setup should look like this:
- PiCtory Configuration
- 2019-04-26 13_12_27-PiCtory - 1.4.1.png (159.53 KiB) Viewed 6626 times
Hello,
that the same problem i have. Is there any solution to read the seriell Data? May be a example script?
that the same problem i have. Is there any solution to read the seriell Data? May be a example script?
Hi, please have a look at the documentation of the Scripter for an example script. Here is a script that connects a weather station
