Hi,
I am using a Revpi Core connected to a Revpi DIO Module and I would like to set the system to reboot after certain time when it notices that the running code hangs on or when due to unknown problems it fails to execute.
I read in the forum that this is possible from with the hardware watchdog implemented in the Revpi Connect. I would like to know how I could implement this in my system.
Is there any configuration file to install and configure it on the Revpi Core?
Any help is much appreciated.
Thanks!
System Watchdog
Basically, no. This is a piece of hardware in our RevPi Connect which cannot be replaced by software.
In a RevPi Core there is a way to somehow monitor your sw and react by kernel driver switching the outputs to off when the application is no longer writing data to the PI ( see here: viewtopic.php?f=41&t=807 ). But you would need to use a special IOCTL call to write data to the PI cyclically
In a RevPi Core there is a way to somehow monitor your sw and react by kernel driver switching the outputs to off when the application is no longer writing data to the PI ( see here: viewtopic.php?f=41&t=807 ). But you would need to use a special IOCTL call to write data to the PI cyclically
Unser RevPi Motto: Don't just claim it - make it!
