Hi,
I am trying to get up and running on codesys with my revpi. I have been following the quick start guide however when i go to compile the code it fails and i get the following error. removing the device allows code to be compiled.
[img]http://imgur.com/a/tBSiXVs[/img]
If i swap to the project type "CODESYS control for raspberry pi SL (CODESYS gmbH)" the project will compile however the pi seems to require the 64 version?
Target ID:
0000 0012
Target Name:
CODESYS Control for Raspberry Pi 64 SL
Target Type:
4102
Target Vendor:
CODESYS GmbH
Target Version:
4.10.0.0
https://imgur.com/irvuqov
Cannot compile code after added revolution pi device
-
dmason1992
- Posts: 5
- Joined: 27 Jan 2021, 17:53
-
dmason1992
- Posts: 5
- Joined: 27 Jan 2021, 17:53
Re: Cannot compile code after added revolution pi device
Solved by replacing the pi image with the bullseye one that is NOT 64bit
Re: Cannot compile code after added revolution pi device
Hi dmason,
you are right. Currently, the 64bit image is not supported. If you would like to use CODESYS on the RevPi, please install the 32bit version to download here.
Have also a look at our codesys checkliste.
Best Regards
Ulrich Kouatang Biakoup | Technical Support
you are right. Currently, the 64bit image is not supported. If you would like to use CODESYS on the RevPi, please install the 32bit version to download here.
Have also a look at our codesys checkliste.
Best Regards
Ulrich Kouatang Biakoup | Technical Support
