CODESYS - DI configuration via CODESYS not working

[hrco86]

Dear Ulrich
thank you very much.

Unfortunatey I cannot find option to post a new topic so I write here.

I have following problem in my Connect+ Codesys projct. Error message in attachment.

Error out of range.PNG (3.96 KiB) Viewed 5615 times

I disabled my GPIOs_A-B since I m using RevPi Status and RevPiLED registers.

Project configuration.PNG (34.71 KiB) Viewed 5615 times

What could cause the problem?

Best

[hrco86]

I managed to locate problem: Problem is that I can alllocate maximum of 4096 MODBUS registers via COdesys using MOdbus TCP slave. Can this be changed?