imaging failed to proceed around 26%

[kwang]

Hello there,

I have a 32G RevPi Connect+ on which I was trying to load the 2022 05 25 revpi buster image through the win32diskimager, but kept failing around 25%.
power reset didn't help either and screen capture uploaded as blow:

would you help to figure out what the problem is pls?

[nicolaiB]

Maybe the wire, which disables the hardware watchdog is missing on connector X4?

-Nicolai

[u.biakoup]

Maybe the wire, which disables the hardware watchdog is missing on connector X4?
For more Information see here https://revolutionpi.com/tutorials/uebe ... g-connect/

Best Regards

Ulrich Kouatang Biakoup | Technical Support

[kwang]

jumper cable is in as pic shows.


and with this same cable I have imaged the other one, on the left side in picture for many times, no any issue with it

[u.biakoup]

Hallo Kwang,
I have some instructions for you.

Please use the software balenaEtcher instead of Win32DiskImager.
https://www.balena.io/etcher/
We have a new Image from 08/2022 on our homepage. You can fash it on your Device: https://revolutionpi.de/tutorials/downloads/
Maybe make sure you are using anew version of RPI Boot.
We have a Revolution Pi RPI Boot Checklist

Best Regards

Ulrich Kouatang Biakoup | Technical Support

[kwang]

balena didn't work either.

any idea about the root cause?

[u.biakoup]

Hello Kwang,
Have you tried with another wire?
The same problem occurs when the wire is nit stable or defective.
please try with another wire.

Best Regards

Ulrich Kouatang Biakoup | Technical Support

[kwang]

tried with diffrent usb cables, power reset my pc, etc.

[u.biakoup]

Hi Kwang,
Could you try with another pc? If the problem is RPI-BOOT. Please have a look on Revpi Boot checklist.

Best Regards

Ulrich Kouatang Biakoup | Technical Support