Dear all, Im new to the RevPi world (and automation in general). I would like to know if its possible to read analog sensor in mV range. The sensor in question has a range of 0-35mV and a resolution of (approximately) 15.00µV. Will the AIO have sufficient resolution for this measurement using the 0-1V input? If not, what solutions can be implemented for this particular type of sensor?
Thank you in advance for the support.
Reading mV with AIO
Hello,
In the following link you will find the datasheet of the RevolutionPi AIO, below you will find the resolution and voltage ranges, as well as other data of the AIO.
Data sheet RevPi AIO
Best regards
Giuseppe Pagano
In the following link you will find the datasheet of the RevolutionPi AIO, below you will find the resolution and voltage ranges, as well as other data of the AIO.
Data sheet RevPi AIO
Best regards
Giuseppe Pagano
