Hi,
I am trying to read a distance using an AIO module and this sensor: https://www.ifm.com/mounting/80237716UK.pdf
German version here if you need it: https://www.ifm.com/mounting/80237716DE.pdf
I have set Input1Range to 0 - 10v and I have the brown (24v) and blue (gnd) sensor wires connected to a power source. I have then connected the black (out1) and white (out2) sensor wires to inputs 24 and 28. I've left 26 empty as I'm measuring voltage, not current.
When I read the Input1 value, I'm only seeing a value when the sensor is in range, and then another value when the sensor is out of range but I'm not getting any analog readings in between. It's like it's a digital reading of on/off instead of the voltage? Do you have any ideas?
AIO Proximity Sensor
Hello Jassa,
you need to check your wiring.
You can wire the sensor as shown in the figure below.
I think the range of output 1 and output 2 is 0-24V. The AIO cuts off after 10V. You can connect a voltage divider with the factor 2.4 and then calculate the correct value.
Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support
you need to check your wiring.
You can wire the sensor as shown in the figure below.
I think the range of output 1 and output 2 is 0-24V. The AIO cuts off after 10V. You can connect a voltage divider with the factor 2.4 and then calculate the correct value.
Mit freundlichen Grüßen | Best regards
Giuseppe Pagano | Technical Support