RevPi core 3+ Ethernet led blinking without LAN cable connection

[sofiene]

hello

I have a RevPi core 3+ device and the Ethernet port has stoped working.
When i remove the ethernet câble the two leds do not stop blinking and the ifconfig command shows an IP address assigned to eth0.
I tried using a new system image but the problem still persists.

I would like to know the possible cause to this problem and if this device is repairable.
I would also like to know if using an USB to Ethernet adapter would enable me to access my device over the network.
and thank you in advance for your support.

best regards,

[dirk]

Dear sofiene n please try to reset your RevPi Core3+ devices with the following checklist:
https://kunbus-gmbh.atlassian.net/servi ... /836468748
You just have to register with your E-Mail address to access it.
The registration page is currently in German language only so here is a short animation how it works:

[sofiene]

hello Dirk,

thank you for taking the time to help me,

Unfortunatly i have already tried to reset my RevPi core3+ device with the buster system image provided in the official shop and the same problem is still occuring.

[dirk]

Dear sofiene, thank you for your message which is important to me. Please excuse me for being so late. Could you try again with the latest image that we have just released? It is called RevPi Buster (05/2022) (ID: 5435).
You can find it at the following link: https://revolutionpi.com/tutorials/down ... evpiimages