Low Power Mode

jrileycaban · Post by **jrileycaban** » 25 Nov 2021, 01:55

Does the RevPi Connect+ have a low power mode? If so, what is the max current draw in this mode? Specifically I am looking for the maximum current expected at turn-on.

Thank you for your help,
Jessica

->Johannes<- · Post by **->Johannes<-** » 30 Nov 2021, 11:00

Dear Jessica,

Does the RevPi Connect+ have a low power mode? If so, what is the max current draw in this mode?

No, there is no low power mode.

Specifically I am looking for the maximum current expected at turn-on.

I have just started a Connect, at 24 V it ran up to approx. 0.21 A at start-up and has settled at 0.15 A.
However, this also depends on your setup.
Our documentation gives the following values:

Max. power consumption 20 Watt (incl. 1 A total USB output current) --> The average power consumption without USB load varies greatly and depends on the use of the interfaces, the GPU and the CPU. It is usually well below 4 watts without HDMI.

Please check RevPi Connect+ Datasheet

regards
Johannes

jrileycaban · Post by **jrileycaban** » 30 Nov 2021, 20:16

Thank you very much for the information - this is helpful.

Could you tell me if the current changes if running off of a 12V supply?

Thanks again!
Jessica

->Johannes<- · Post by **->Johannes<-** » 02 Dec 2021, 11:38

Dear Jessica,

Could you tell me if the current changes if running off of a 12V supply?

yes, the current will increase.

Regards
Johannes