I've read that the Connect+ feat. Codesys does not support the M-Bus module. Any chance to get meter readings into the Connect+ and Codesys, maybe through a workaround?
And can someone explain why this restriction applies? I've found a Wago solution which allows to seeing M-Bus data via Codesys,.
Thanks!
M-Bus + Codesys?
Hi user,
what makes you think that? Where did you read this?
The M-Bus gateway exists in our library, attached is an example:
Regards
Johannes
what makes you think that? Where did you read this?
The M-Bus gateway exists in our library, attached is an example:
Regards
Johannes
Sorry for the late feedback.
Please see here: https://revolutionpi.de/revpi-connect-codesys/
It says:
The field of compatible extension modules does not list the M-Bus device.
I also checked it out in Codesys, I can't find any options to add it:
Please see here: https://revolutionpi.de/revpi-connect-codesys/
It says:
Also, have a look here: https://revolutionpi.de/shop/de/mbus-module* keine RevPi Con MBus (Artikelnr.: 100281) und RevPi Con MBus VHP Gateway (Artikelnr.: 100282) Unterstützung.
The field of compatible extension modules does not list the M-Bus device.
I also checked it out in Codesys, I can't find any options to add it:
Hi Dirk,
Do you already have enabled the mbus module in the webinterface and updated the module setup in pictory? If not, please have look at our tutorial section.
Nicolai
Do you already have enabled the mbus module in the webinterface and updated the module setup in pictory? If not, please have look at our tutorial section.
Nicolai