Change OS Base Module Config ?

[Aurelog]

Hello World !

I am working on my first company project with Revpi using Revpi Core 3+, it succesfully works (with just 1 another major issue that need to be investigate on my side)
I have another similar project but with RS-485, so i used Revpi Connect+.

I made image copy from Core 3+ then burn it on Revpi Connect+. It boots but got some issues with pictory (no values, multiple devices detected, no RS485, only one ethernet port).

Is there a way to change the OS Base Module configuration without burning from Buster image ? Or re-run script done at first login (Base module choice, Serial Id, Mac Address) ?

In order to avoid reconfiguring the entire OS (softwares, security etc...).

Thank you,

Aurelog

[dirk]

Hi, we have to review your post more deeply but until then have a look here: viewtopic.php?f=6&t=2866&p=10620&hilit= ... ory#p10620

[dirk]

Hi, have a look here: RevPi Cloning Tutorial