I rearranged my setup and took MIO out completely. So now I have 1xDIO and 2xAIO and it works perfect.
Do you think there is an issue in general if you use all 3 modules (AIO, MIO, DIO)?

thanks

Hello Nicolai,

If I use the revpimodio library, wouldn't be easier? Are there any variables there for modules health?

thanks

Hello, I want to make some tests regarding the modules (AIO/MIO/DIO) I have connected to my revpi. So if I need to check modules status, and by status I mean connectivity to revpi, power on/off, which variable should I check? Should I only check RevPiStatus bytes 1,2,3,4? Also are there any specific...

You misunderstood. I changed the modules and the problem persists, so it shouldn't be a hardware issue!

Hello again,

The problem is not solved after all. Tell me what kind of info you need in order to make a step-by-step debugging!

thanks

I finally changed all the modules. I followed the updated procedure and everything worked like a charm. So I guess there are some issues with the 1st set of modules.

Thats my setup now, after updating each module one by one following your guide (https://revolutionpi.com/tutorials/images/firmware-update/) pi@RevPi84278:~ $ piTest -d Found 4 devices: Address: 0 module type: 105 (0x69) RevPi Connect V1.0 Module is present input offset: 319 length: 6 output offset: ...

Thanks for the reply.

So I just need to change the revpi edition to Connect SE, in address 0 and reload revpi?
I changed it!
I keep getting the same error
I am attaching the pictory config as well

Thanks I will!

Hello, I am having the below format (attached as well) AIO|MIO|DIO|Connect+SE (16GB) and I am receiving the below error: Jan 20 11:34:15 RevPi84278 kernel: piControl: recv len from pibridge err(got:0, exp:20) Jan 20 11:34:15 RevPi84278 kernel: piControl: talk with mio for dio data error(addr:30, ret...