Thank you for the link - but is it possible to just get the part numbers for the connectors? I am not sure the Maker-Set enclosure will work for my application.

Thanks!

Just wanted to ping again and ask what the part numbers are for the RevPi ConBridge or PiBridge connectors?

Hello,

What is the mating connector part number for the RevPi Con Bridge? I'd like to attach a custom board to the RevPi Connect using the bridge connector. Are there any drawings for how properly position the mating connector?

I see in the schematics that it looks like the +24V supply input ground (GND_P) appears to be isolated from signal ground (GND) with only a capacitor (C123) in between the two. I would like to use the Conbridge SPI/UART outputs for some additional features, but I would like to reference those circui...

Thanks for the info. As for the schematics - are those available?

Are there schematics available for the RevPi Con CAN module?

I see the ConBridge has both SPI and UART - are both required for the Con CAN module or can I use one for other functions while still using the CAN module?

Thank you very much for the information - this is helpful.

Could you tell me if the current changes if running off of a 12V supply?

Thanks again!
Jessica

Does the RevPi Connect+ have a low power mode? If so, what is the max current draw in this mode? Specifically I am looking for the maximum current expected at turn-on.

Thank you for your help,
Jessica